Automotive EMC Test Solutions
The automotive industry has very specific and permanently changing requirements for EMC testing with pulses and waveforms getting more and more complex. As the leading manufacturer of automotive test equipment and member of various national and international standard working groups EM TEST knows the present and the future demands of the car industry.
The automotive test equipment listed below are well designed to meet the EMC testing requirements of the automotive industry - today and tomorrow:
Automotive Transient Emissio...
Model : Transient Emission Set-iso-7637-2
＊BS 200N100 - Electronic switch, 60V DC/100A:
＊Volt.Drop <1.2V@100A, <0.2V@25A
＊Peak voltage max. 1,000V
＊Reverse-polarity/short-circuit protected
＊BSM 200N40 - Mechanical switch, 12/24V DC/40A
＊.......
Single-line Artificial Netwo...
Model : AN 2050N Series
＊Artificial Network as per ISO 7637 or CISPR 25/ ISO 11452-4
＊Frequency range: 100kHz - 108MHz
＊DC voltage max. 400V
＊AC voltage max. 250V (up to 1kHz)
＊Current max. 50A AC/DC cont.
＊.......
Load Impedance for BS200Nx E...
Model : CA BS 200N
＊Verification load for electronic switch 0.6ohm / 50uH as per ISO 7637-2:2004
＊Max. supply voltage 28VDC
＊Max. load current 50A
＊Additional shunt resistors 10ohm, 20ohm, 40ohm, 120ohm built-in for emission measurement
＊Over-temperature protected
Ultra Compact Simulators for...
Model : UCS 200N
＊Built-in EFT/Burst generator module
＊Built-in Micropulse generator module (ISO 7637, JASO, SAE and NISSAN)
＊Built-in coupling network 80V, up to 200A
＊Built-in battery switch
＊Overcurrent protection
＊......
Load Dump Generator with Cli...
Model : LD 200N
＊Load Dump generator according to ISO 7637, ISO 16750-2, SAE J1113, SAE J1455, JASO, Nissan and most car manufacturer requirements
＊Generates Clipped Load Dump pulses
＊Built-in 0.5 - 38 Ohm source impedance, selectable in 0.1 Ohm steps
＊Pulse duration up to 1,200ms
＊.......
Load Dump Generator with Cli...
Model : LD 200N100
＊Load Dump generator according to ISO 7637, ISO 16750-2, SAE J1113, SAE J1455, JASO, Nissan and most car manufacturer requirements
＊Built-in 100A couppler 60 V/100 A
＊Built-in battery switch for 100A
＊Generates Clipped Load Dump pulses
＊Pulse duration up to 1,200ms
＊.......
Load Dump Generator with Cli...
Model : LD 200N200
＊Load Dump generator according to ISO 7637, ISO 16750-2, SAE J1113, SAE J1455, JASO, Nissan and most car manufacturer requirements
＊Built-in 200A couppler 60 V/200 A
＊Built-in battery switch for 200A
＊Generates Clipped Load Dump pulses
＊Pulse duration up to 1,200ms
＊......
Generates and records automo...
Model : AutoWave
＊Dual-Processor-Technology, 500kS/s sample rate
＊4-channel arbitrary generator
＊2-channel transient recorder
＊Simultaneous recording/generation
＊Library of standard test routines
＊.......
Voltage Drop Simulator - Bat...
Model : VDS 200N
＊Voltage up to 60V
＊Current up to 200A (peak up to 1,000A)
＊Bipolar-amplifier models available
＊Low output impedance
＊Powerful DC voltage source
＊......
Automotive Power Fail Simula...
Model : PFS 200N
＊Standalone test generator for voltage dips and interruptions
＊Rise/fall time <1us
＊Electronic short-circuit protection
＊Rated voltage 80V DC
＊Front panel operation
＊.....
Automotive Power Fail Simula...
Model : PFM 200N100.1
＊Switch for Power supply (100 A) and signal/data lines (2 A)
＊Pulses E10 and E13 of the LV 124/LV 148 standard
＊Bidirectional current direction
＊Separate switch in the ground line
＊Rise/fall time less than 200ns
＊......
Low frequency signal source ...
Model : AMP 200N
＊Built-in DDS to generate sinusoidal signals up to 250kHz
＊Built-in LF amplifier, 250W
＊Output voltage max. 140V p-p, 50V rms
＊Output current max. 5A rms
＊Programmable DC voltage offset
＊.......