Single Phase AC Voltage Source 3 kVA

ACS 500N3 is a single phase AC source, specifically designed for harmonics and flicker testing. 

It meets the corresponding specifications as per EN/IEC 61000-3-2 and EN/IEC 61000-3-3 as well as JIS C 61000-3-2. 

ACS 500N3 provides the perfect sinusoidal and stable voltage signal specified to perform fully compliant harmonics and flicker analysis despite of the mains supply frequency and steadyness of the voltage.

Sinusoidal Voltage for Harmonics and Flicker Measurements

As per standard requirements a pure voltage is needed for measurements of harmonics and flicker. The output voltage of the ACS 500N3 is guaranteed to be sinusoidal with a very low distortion (THD) of less than 0.1% regardless of the load. Furthermore the voltage is kept stable within 0.1% independent of the load, even if the load is variable.

No matter what the condition of the mains supply might be ACS 500N3 fulfills the high standard for purety and stability of both the sinuoidal voltage signal and the frequency. With its power of 3,000VA it can be used for measurements as per EN/IEC 61000-3-2 and EN/IEC 61000-3-3 as well as JIS C 61000-3-2 on DUTs with small power consumption, not exceeding 10A of nominal current for resistive load. 

The ACS 500N3 AC voltage source is electronically protected against overtemperature, overcurrent, overvoltage and undervoltage.

Used with EM TEST DPA 500 Series harmonics and flicker analyzers ACS 500N3 is fully remote controlled by dpa.control software via RS232 interface.